9320-99-438-2876

Documents 6680-00-879-9309 5+ Documents ( More... ) https//www.nsnlookup.com /fsg-93/fsc-9320/uk 9320-99-438-2876
Solid Rubber Sheet 9320994382876 994382876 valve, graphite impregnated and lubricated items. https

4120-00-913-8898 4120009138898 009138898 is a self-contained unit designed to perform the functions of cooling, circulating, filtering, dehumidifying or otherwise processing of air. it may also be equipped to perform the additional functions of heating or humidifying. it may be the air cycle type used in aircraft or the vapor cycle type applicable to ground or aerospace equipment. excludes environmental control unit, personnel, self-contained.

enable JavaScript in your web browser . 3439-15-144-5923Punta Ersa3439151445923 151445923 LU6238-00 32C5
Italiana Spa (Active) Primary Buy RNCC 3 RNVC 2 DAC 5 32C5 A3125 - G.B.C.

4730-01-541-8414 4730015418414 015418414 is a fitting that forms an angle of less that 180 degrees (3.141 radians) from a straight flow. one connecting end has machine threads (straight threads other than pipe or hose series) designed to accommodate a tube or is unthreaded and designed to accommodate a tube. the other end has external or internal machine threads (straight threads other than pipe or hose series) and is designed to facilitate a gasket, preformed packing, washer, or the like, to form a seal at the boss. it may have side or heel inlet(s). it is designed to connect a tube or tube fitting to a boss or boss fitting on items such as tanks, housings, valve fittings, or the like.

5310-01-615-7614 5310016157614 016157614 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.