8415-26-300-2669

9530-27-011-3247 9530270113247 270113247 is a metallic product of ferrous or nonferrous material. it is produced as a solid section in straight lengths or short barlike forms of cored or solid cross section. it may be round, square, hexagon, oval, half-oval, or half-round shape whose width, diameter, or distance between parallel faces is 3/8 inch or 10.0mm or greater. rectangular shape cross-sectional dimensions are limited to those established in appendix c, fiig a131. it is round to a maximum diameter of 24 inches or 610.0mm. for a rectangular shape less than 3/32 inch or 2.5mm thickness, see wire (1), nonelectrical.

5905-99-011-3247 5905990113247 990113247 is a resistor whose ohmic value cannot be adjusted or varied. the resistance element consists of high resistance wire (or ribbon) either wound on an insulated form or constructed so as to be self supporting. opposition to the flow of current is an inherent property of the resistance wire and is manifest by the heat dissipation in the resistor. excludes suppressor, ignition interference.

5306-21-011-3247 5306210113247 210113247 is an externally threaded fastener whose threaded portion is of one nominal diameter, and whose unthreaded portion has been machined or ground in one or more places or over its entire length to a maximum diameter less than the minimum pitch diameter of the thread (excludes undercuts for thread relief). it is no. 10 (0.190 in.) (5 mm) or larger in size and has a head which is not designed to be held or driven with an inserted driver or designed for rotation by the thumb and fingers. a locking feature may be incorporated in the design of the head or threads. excludes bolt, internal wrenching and thumbscrew. see also screw, externally relieved body.

5905-99-011-3247 5905990113247 990113247

5307-00-011-3247 5307000113247 000113247 is a headless fastener not exceeding 12 inches (304.8 mm) in length, threaded externally on both ends with threads of the same nominal diameter. the maximum diameter of the unthreaded portion must not be greater than the nominal thread diameter plus 0.020 inches (0.508 mm). the unthreaded portion must be without locking or wrenching provisions. it may be thread relieved. see also rod, threaded end and rod, continuous thread.