6675-12-340-1019

Aug 1987 6675-12-309-7221 Technical Fountain Pen 158035RNCC: 3 | RNVC: 9 | DAC: 6 19 Feb 1987 6675-12-340-1019

DAC: 3 31 Mar 1988 7520-12-162-5787 Marking Stencil 5710RNCC: 3 | RNVC: 2 | DAC: 3 30 May 1969 6675-12-340-1019

3040-15-050-1308 3040150501308 150501308 is an item designed to be mounted around a shaft to limit axial movement of the shaft and/or its assembled parts. it is secured directly to the shaft by use of a setscrew(s), pin(s), or the like, which may be a part of the item of supply. a pilot hole drilled in or through the wall(s) for drilling and pinning at application may be considered a method of securing. solid items have a bearing surface on one or both end(s) perpendicular to the axis. for items designed to be mounted around the extended hub portion of a mounted item on a shaft or clamp around a shaft, see clamp, hub. see also bearing, sleeve; bushing, sleeve; spacer, sleeve; and coupling, shaft, rigid.

5310-01-050-1308 5310010501308 010501308 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

15 Aug 2005 5820-17-109-5085 Detectieapparatuur 1200010RNCC: 5 | RNVC: 2 | DAC: 3 14 Nov 1995 6675-12-340-1019