6110-14-316-8170

28 Jul 1999 6110-14-297-8488 Frequency Regulator MF195RNCC: 3 | RNVC: 2 | DAC: 2 1 Jan 1973 6110-14-316-8170

5961-14-322-6673 5961143226673 143226673 is an active semiconductor device with three or more electrodes. may or may not include mounting hardware and/or heatsink. excludes semiconductor device, diode and semiconductor device, thyristor. for solid state devices which are responsive to visible or infrared radiant energy, see semiconductor device, photo.

4140-01-122-4050 4140011224050 011224050 is a nonpositive displacement mechanical device without guide vanes and having an axial fan impeller inclosed within a tubular housing. it is designed primarily for duct installation to move air or gas axially over a wide range of volumes at medium pressures.

5970-14-315-0358 5970143150358 143150358 is an insulator having flat surfaces, with or without holes, whose thickness does not exceed 25 percent of its length or width, whichever is smaller, and whose shape is other than round. excludes insulator (1), spacer; insulator (1), washer; mounting pad, electrical-electronic component; plate, electrical shield; and terminal board.

5365-14-508-4573 5365145084573 145084573 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.