5998-12-346-8244

2510-15-193-2201 2510151932201 151932201 is a rigid item of various shapes specifically designed to cover a lateral ingress or egress opening of a vehicle cab. the item may be attached by means of hinges or similar devices and closed with a latching device. necessary hardware and/or fastening devices as well as the door panel are included. it may include one or several integrated or slip-on observation windows. excludes door, hatch, vehicle and door, metal, swinging.

5940-99-193-2201 5940991932201 991932201 is an item consisting of insulating material, which is specifically designed to have fastened thereon, or on which are fastened terminal(s), such as screws, solder lugs, solder studs, solderless connectors, clips, and the like. it is usually used for junctions or terminations of wire or cable assemblies. it does not include items as defined above with parts, such as resistors and capacitors mounted thereon. do not use if a more specific name exists, such as fuseholder; holder, resistor; fanning strip; contact assembly, electrical; jack assembly, tip; chamber, cable terminal; panel (2) (as modified); connector (as modified). excludes terminal, stud; terminal, feedthru, insulated; post, binding, electrical; and chassis, electrical-electronic equipment. for items having printed electrical conductor paths, see printed wiring board.

5365-12-193-2201 5365121932201 121932201 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.

6625-00-193-2201 6625001932201 001932201