5975-01-303-8365

www.nsnlookup.com /nato/nato-stock-numbers/inc Junction Box (INC 06219) Junction Box 11 Jul 1989 5975-01-303-8365

Sep 1989 5975-01-306-0531 Junction Box 16 Aug 1989 5975-01-304-0056 Junction Box 11 Jul 1989 5975-01-303-8365

1015-37-507-6641 1015375076641 375076641 is a rigid item of various cross-sectional shapes, specifically designed to provide support and/or reinforcement to a gun mount pedestal.

5940-00-507-6641 5940005076641 005076641 is an item consisting of insulating material, which is specifically designed to have fastened thereon, or on which are fastened terminal(s), such as screws, solder lugs, solder studs, solderless connectors, clips, and the like. it is usually used for junctions or terminations of wire or cable assemblies. it does not include items as defined above with parts, such as resistors and capacitors mounted thereon. do not use if a more specific name exists, such as fuseholder; holder, resistor; fanning strip; contact assembly, electrical; jack assembly, tip; chamber, cable terminal; panel (2) (as modified); connector (as modified). excludes terminal, stud; terminal, feedthru, insulated; post, binding, electrical; and chassis, electrical-electronic equipment. for items having printed electrical conductor paths, see printed wiring board.

5365-14-507-6641 5365145076641 145076641 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.