Documents 9515-01-592-4491 1+ Documents ( More... ) https//www.nsnlookup.com /fsg-59/fsc-5950/us 5950-00-865-1109
Contact Coil 5950008651109 008651109,694-2 assortment, gasket; and bearing, washer, thrust. https
5950-99-554-3098 5950995543098 995543098 TRANSFORMER,POWER,STEP-DOWN
3120-00-431-1643 3120004311643 004311643 is a tubular shaped item with or without flange(s) designed to reduce friction and carry a kinetic load on the surface(s) parallel to the axis of the bore. it must have a visible or detectable means of lubrication or be self-lubricated. the over all length must exceed 25 percent of the outside diameter or the shortest distance between peripheral flats of the body, except for straight tubular (without flange or shoulder) items having a bearing surface(s) parallel to the axis of the bore only. includes items which are divided into two or more segments which include 180 degrees (3.141 radians) or less of the bearing periphery. see also bushing, sleeve; spacer, sleeve; and washer (as modified). excludes pin, hollow.
5975-99-953-4826 5975999534826 999534826 is an item of metal and/or insulating material having internal threads designed to fit over the end of electrical conduit and/or fittings to provide a smooth interior with a rounded edge to prevent damage to the insulation of the wire or cable emerging therefrom. it may be designed to fit over the end of thin wall conduit, and to be fitted with holding (staking) screws, or it may be provided with internal straight threads for attaching to thick wall electrical conduit or fittings. it may be fitted with a temporary knockout cap (bushcap), and grounding or bonding facilities. for externally threaded items, see box connector, electrical; bushing, electrical conductor; chase nipple, conduit and bushing, strain relief, cable. see also ferrule, electrical conduit. excludes plain sleeve bushings.
5365-01-073-6055 5365010736055 010736055 is a thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole and having a solid rectangular cross-section use disk, solid, plain. items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. for items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. when thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. see also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.