5950-14-261-9715

2920-63-000-0066 2920630000066 630000066 is a generator primarily designed to be mounted on an internal combustion engine, and to be driven by the engine to keep the battery in a charged condition. may also supply current for the engine ignition system and/or electrical equipment which is connected to the battery circuit. includes alternating current generators designed for use with a rectifier. excludes the major generator of "generating sets". for generators specifically designed for aircraft use and not mounted on the engine, see generator, direct current.

5410-42-000-0066 5410420000066 420000066 is a portion of, or a complete wall, ceiling, roof or floor of a prefabricated structure produced at the factory according to standardized specification. these panels consist of a frame being faced on one or both surfaces with an exterior covering. panels may include windows, doors or frames for same, wiring, piping or insulation.

5960-99-000-0066 5960990000066 990000066 is an inclosure, including two or more electrodes, in which a flow of electrons may occur through a vacuum or a contained gas. the electronic conduction takes place either by means of electrons emitted from a cathode or by ionization of the contained gas. includes phototubes (photoemissive type only), geiger-mueller tubes, traveling wave tubes, cathode ray tubes and microwave tubes (klystron, magnetron, or the like). excludes items whose primary purpose is to produce light energy. also excludes photoelectric cell; and semiconductor device (as modified).

8415-55-000-0066 8415550000066 550000066 is an undergarment, usually long-sleeved, primarily designed for protection at mean monthly temperatures of plus 14 degrees fahrenheit (minus 10 degrees celsius) to plus 68 degrees fahrenheit (plus 20 degrees celsius). excludes undershirt, man's; undershirt, extreme cold weather; undershirt, moisture wicking and undershirt, woman's.

3040-45-000-0066 3040450000066 450000066 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.