5910-99-722-5169

3040-99-993-9753 3040999939753 999939753 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.

3040-99-127-2427 3040991272427 991272427 ARM ASSEMBLY,LINK

4820-99-425-4395 4820994254395 994254395 is an item in the form of one or more thin flexible sheets normally designed to form a tight seal between chambers of a valve, and to transmit motion to a valve disk either directly or through a mechanical linkage. the surface of the item(s) may not be formed or molded to have a beaded or rolled edge, ribs, or any other raised surfaces. the item may contain bolt holes and/or a center hole. excludes diaphragm, valve, special shaped and gasket.

5910-99-656-4800 Electrolytic Fixed Capacitor 00054663RNCC: 5 | RNVC: 2 | DAC: 2 25 Apr 1991 5910-99-722-5169

3040-99-192-1823 3040991921823 991921823 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.