5820-25-130-5789

9 1 Jan 1984 5805-25-131-5600 Telephone Set Case 756-20RNCC: 6 | RNVC: 9 | DAC: 9 1 Jan 1984 5820-25-130-5789

1720-99-761-1034 1720997611034 997611034 FLANGE,HUB

5340-01-366-1541 5340013661541 013661541 is an item specifically designed to fit into the opening(s) of various items to provide mechanical protection and/or prevent the entrance of foreign matter during painting, shipping storage, or the like. it is not designed to retain fluids under pressure during equipment operation. excludes plug (as modified) and stopper, bottle. for items designed to fit into or over the opening(s) of various items, see cap-plug, protective, dust and moisture seal.

3040-01-669-2249 3040016692249 016692249 is an item of various cross-sectional shapes which may be of solid or hollow construction. it is specifically designed for attachment to a lever(s) and/or control(s) to actuate various remote mechanisms. it is one of the following: (1) a one-piece item with or without eyes and/or holes in each end which may have bushings or bearings pressed in the eyes; (2) a one-piece item with both ends processed for terminations, excluding threaded end(s); (3) a two-piece construction type item consisting of a body with both ends processed for terminations and a single end attachment; or (4) a three-piece construction type item consisting of a body and two end attachments. excludes internal combustion engine type piston connecting rods; drag link, steering; link, anchor, brake shoe; tie rod, steering; and turnbuckle. for cylindrical shaped externally threaded items without end attachments, see rod, threaded end and stud (as modified).

5365-01-440-4468 5365014404468 014404468 is a thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole and having a solid rectangular cross-section use disk, solid, plain. items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. for items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. when thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. see also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.