5530-00-128-5376

United States (US) 4. 5530-00-128-5376 Marketplace Restrictions Approved Sources Datasheet Management
RQST Updated Every Day 5530-00-128-5376 RQST NE Related Documents 5530-00-128-5376 3+ Documents ( More
RQST Updated Every Day 5530-00-128-5376 RQST NE Related Documents 5530-00-128-5376 3+ Documents

5310-99-732-3689Cap Plain Nut5310997323689 997323689 SSK/Y/327/40/0402/170 Y/327/40/0402/170/001 001285376
Y/327/40/0402/170/001 SSK/Y/327/40/0402/170/001/01 Y/327/40/0402/170 Y/327/40/0402/170 SHEET 001 001285376
001285376 SHEET 01 Y/327/40/0402/170/001/01 QCA/SSK/Y/327/40/0402/170 An item internally threaded from

Restrictions 5530-00-128-4405 DEMIL: B | DEMILI https//www.nsnlookup.com /fsg-55/fsc-5530/us 5530-00-128-5376
5530001285376 001285376 327/40/0402/170 An item internally threaded from https//www.nsnlookup.com
us 5530-00-128-4405 55300012844050012844055530-00-128-44055530001284405001284405 Restrictions 5530-00-128-5376

5305-12-148-1758 5305121481758 121481758 is an externally threaded fastener designed for insertion into holes in assembled parts, for mating with a preformed internal thread and for tightening or releasing by torquing the head. the threaded and unthreaded portions are both of the same nominal diameter of 0.190 inch (5 mm) or larger. head dimensions and sizes of threaded and unthreaded portions shall conform to internationally recognized fastener standards. the thread length being the controlled dimension, the grip length is not specified. a locking feature may be incorporated in the design of the head or threads. the head is not designed to be held or driven with an inserted driver or by the thumb and fingers. excludes bolt,machine; bolt,externally relieved body; bolt,internal wrenching; and screw,cap,socket head.

5310-99-532-6554 5310995326554 995326554 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.