5340-13-114-6881

5340-23-111-2309 5340231112309 231112309 BUMPER RUBBER

4730-17-111-2309 4730171112309 171112309 is a fitting that forms an angle of less than 180 degrees (3.141 radians) from the straight flow. both connecting ends have standard pipe threads or are unthreaded and designed to accommodate a pipe. it may have side or heel inlet(s). see also elbow, tube; and connector, multiple, fluid pressure line. excludes bend, soil pipe.

6910-99-111-2309 6910991112309 991112309 CIRCUIT CARD ASSEMBLY

5310-15-111-2309 5310151112309 151112309 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

7610-21-111-2309 7610211112309 211112309