5330-99-468-9879

JavaScript in your web browser . 5820-99-949-0957Relay Assembly Group5820999490957 999490957 SDC137853 CP102774
Documents 5820-99-949-0957 3+ Documents ( More... ) https//www.nsnlookup.com /fsg-53/fsc-5330/uk 5330-99-468-9879
Gasket 5330994689879 994689879,CP102774 instructions how to enable JavaScript in your web browser

2 | DAC: 2 25 Apr 1991 5330-99-469-1636 Ring WE506654RNCC: 3 | RNVC: 2 | DAC: 5 18 Jan 1977 5330-99-468-9879

https//www.nsnlookup.com /cage Rank Radio International (CAGE Code K1181) | DAC: 5 18 Jan 1977 5330-99-468-9879

5310-33-161-1665 5310331611665 331611665 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

5310-99-941-1325 5310999411325 999411325 is a nut, flat on top and bottom having 6 flat sides. for items which have internal tapered or straight (parallel) pipe threads, specific electrical conduit size designation, and which when installed, provide a method of tightening to lock the connection, see locknut, electrical conduit. see also locknut, tube fitting. for items having a thickness (or height) exceeding two times the width across the flats, use post, electrical-mechanical equipment. (when height or thickness and/or width across the flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance.)