5310-01-339-3992
Flat Washer
5310013393992 013393992 92485077
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items. View more Flat Washer
November 2023
8
Marketplace 5310-01-339-3992
Request a Quotation from participating marketplace vendors
Related Documents 5310-01-339-3992 3+ Documents (More...)
Restrictions 5310-01-339-3992
5310-01-339-3992 is a Flat Washer that does not have a nuclear hardened feature or any other critical feature such as tolerance, fit restriction or application. Demilitarization of this item has been confirmed and is not currently subject to changes. This item is considered a low risk when released from the control of the Department of Defense. The item may still be subject to the requirements of the Export Administration Regulations (EAR) and the Code of Federal Regulations (CFR). This item is not suspected to be hazardous. The precious metals content of this item is unknown.
Approved Sources 5310-01-339-3992
- Part Number
- Manufacturer
- Status
- 92485077
- Manufacturer
- 33968 - Clark Equipment Co (Active)
- Original Design
- Original Design
- 92485077
- 522L7 - Doosan International Usa Inc Div (Replaced)
- Advisory Reference
- Advisory Reference