5310-33-001-7965
Flat Washer
5310330017965 330017965 STANDARD/M12/FE-ZN DIN125-12
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items. View more Flat Washer
July 2023
1
Marketplace 5310-33-001-7965
Request a Quotation from participating marketplace vendors
Related Documents 5310-33-001-7965 3+ Documents (More...)
NumberManufacturerStatus125 15526 - Metric And Multistandard (Active) Original Design RNCC 3 RNVC 9 DAC 4 DIN125-12
Restrictions 5310-33-001-7965
End Users 5310-33-001-7965
- Spain (YB)
Approved Sources 5310-33-001-7965
- Part Number
- Manufacturer
- Status
- DIN125-12
- Manufacturer
- 0456B - Celo Sa (Active)
- Primary Buy
- Primary Buy
- STANDARD/M12/FE-ZN
- D8286 - Din Deutsches Institut Fuer Normung (Active)
- Incomplete Standard
- Incomplete Standard