5310-12-348-5441

5307-00-206-9101 5307002069101 002069101

3465-01-206-9101 3465012069101 012069101 is a fixture specifically designed to be used with an arbor press, to aid in maintenance and repair, or the like. excludes inserter (as modified); puller (as modified), and remover (as modified).

4730-99-206-9101 4730992069101 992069101 COUPLING ASSEMBLY,Q

5340-33-206-9101 5340332069101 332069101 is an item specifically designed to fit into or over the opening(s) of various items to provide mechanical protection and/or to prevent the entrance of foreign matter during painting, shipping, storage, or the like. it is not designed to retain fluids under pressure during equipment operation. for items designed to fit only into an opening, see plug (as modified) and stopper (as modified). for items designed to fit only over an opening, see boot (as modified); cap (as modified); cover (as modified); and hood (as modified).

5310-14-206-9101 5310142069101 142069101 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.