5120-25-100-0907

2510-00-907-3752 2510009073752 009073752

2789 Mechanical Puller 5120-25-136-2202 Mechanical Puller 5120-22-117-8635 Mechanical Puller 5120-25-100-0907

5340-33-108-2503 5340331082503 331082503 is a standoff that must have a threaded end(s) or be internally threaded its full length. for items having external threads on both ends, see stud (as modified). for items with an outside contour that is the same for the entire length, are flat on top and bottom, having internal threads its full length, and the length does not exceed twice the width across the flats or outside diameter, see nut (as modified); use maximum dimensions(s) for compliance.

5340-33-108-2502 5340331082502 331082502 is a standoff that must have a threaded end(s) or be internally threaded its full length. for items having external threads on both ends, see stud (as modified). for items with an outside contour that is the same for the entire length, are flat on top and bottom, having internal threads its full length, and the length does not exceed twice the width across the flats or outside diameter, see nut (as modified); use maximum dimensions(s) for compliance.

5365-33-200-9809 5365332009809 332009809 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.