5120-33-106-4223

3020-14-210-0348 3020142100348 142100348 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

5355-14-210-0685 5355142100685 142100685 is an item designed to transmit manual, rotary or linear motion to other devices. may include detachable or nondetachable stud (shaft), pointer, or skirt. it may have reference markings in the form of dots, arrows, hairlines, and/or symbols which may be used in conjunction with a calibrated panel, vernier indicator, and the like to indicate the position or motion of items. for items having spokes or simulated spokes radiating from near the center to near the outside rim of the item and relatively thin round disk-shaped items 3 inches (76.2 mm) in diameter or over, see handwheel. for items calibrated in units or series of divisions to denote relative positioning of devices see dial, control. excludes doorknob; and handle (as modified).

5340-14-210-0214 5340142100214 142100214 is a headless, cylindrically shaped, unthreaded, solid metallic item with or without a drilled hole(s) perpendicular to the axis. its length exceeds 12 inches (304.8mm) and it is of one nominal diameter. one or both ends are squared, chamfered, or rounded. do not use if a more specific item name is applicable. excludes bar, metal and pin, straight, headless.

5935-14-210-8846 5935142108846 142108846 is an item specifically designed to mate with another connector to perform one or more special functions, such as to act as a cover or shield, to short contacts, or to open or close electrical circuits, in or on another connector. it cannot be used as a connector, plug, electrical. excludes dummy plug,telephone.

5999-14-210-3749 5999142103749 142103749 is a clip designed to electrically connect items and components. its primary function is to make a quick and/or temporary electrical connection. includes alligator and crocodile test clips, battery clips, contact clips, electron tube clips, resistor clips, or the like. for electron tube grid and plate cap clips with wire leads attached, see lead, electrical. excludes clamp, electrical; clip, spring tension; and fuseholder (as modified).