5110-21-855-3217

DAC: 3 1 Jan 1963 5110-00-244-9088 Turning Chisel 19-1RNCC: 3 | RNVC: 2 | DAC: 4 1 Jan 1963 5110-21-855-3217

| DAC: 4 6 Jun 1968 5110-21-639-5060 Turning Chisel 476RNCC: 3 | RNVC: 1 | DAC: 6 6 Jun 1968 5110-21-855-3217

| DAC: 9 6 Jun 1968 5120-21-105-1452 Hand Hammer 313716RNCC: 6 | RNVC: 9 | DAC: 9 4 Jun 1968 5110-21-855-3217

5935-12-179-2767 5935121792767 121792767 is two or more connector, plug, electrical; connector, receptacle, electrical; adapter, connector; jack, telephone; jack, tip; plug, telephone; plug, tip; dummy connector, plug; or dummy connector, receptacle in any combination, having a common mounting or mounted on each other, each one capable of being independently replaced. it may be interconnected by means of wire or solder bridgings. for items furnished as mated pairs or sets, see connector set, electrical. excludes dummy connector set, electrical; jack assembly, telephone; jack assembly, tip; plug assembly, tip; and cable assembly (as modified).

5310-01-525-9151 5310015259151 015259151 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.