4940-12-126-0105

6610 Dust And Moisture Seal Protective Cap HP-016-5-74RNCC: 5 | RNVC: 2 | DAC: 9 25 Jan 1999 4940-12-126-0105

18 Sep 2002 4940-22-616-5686 Spray Gun Paint Cup 16742RNCC: 5 | RNVC: 2 | DAC: 4 7 Feb 2008 4940-12-126-0105

5310-01-049-4845 5310010494845 010494845 is a nut, flat on top and bottom having 6 flat sides. for items which have internal tapered or straight (parallel) pipe threads, specific electrical conduit size designation, and which when installed, provide a method of tightening to lock the connection, see locknut, electrical conduit. see also locknut, tube fitting. for items having a thickness (or height) exceeding two times the width across the flats, use post, electrical-mechanical equipment. (when height or thickness and/or width across the flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance.)

MTV TM-9-2320-366-24P-1 Parts Manual - Volume 1 for M1083 Series Medium Tactical Vehicles. Page 255 of 1496.

5310-01-049-4873 5310010494873 010494873 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.