4920-00-708-7455

-223-1275 Linear Actuating Cylinder Assembly 3144380-9RNCC: 3 | RNVC: 2 | DAC: 6 31 May 2006 4920-00-708-7455

DAC: 5 1 Jan 1962 3040-00-706-3614 Spur Gearshaft 373775RNCC: 5 | RNVC: 9 | DAC: X 1 Jan 1963 4920-00-708-7455

5950-15-062-6892 5950150626892 150626892 TRANSFORMER (1), PO

3040-00-382-4363 3040003824363 003824363 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

5930-00-544-5755 5930005445755 005445755 is a switch which is externally actuated by a thumbwheel and/or pushbutton. a legend or message is visually displayed at each position of the indicating wheel which corresponds to electrically coded output. electrically coded output is achieved by rotating a set of brush contacts permanently attached to the code indicating wheel, against a stationary commutator which is usually a printed wiring board having electrical pads or contacts which are interconnected by the rotating brush contacts. may have additional electrical components (such as resistors, capacitors, diodes) premounted on that portion of printed wiring board which extends beyond the back of switch housing.