4820-99-785-3883

1984 5360-99-052-0228 Compression Helical Spring C2113-305RNCC: 3 | RNVC: 2 | DAC: 2 9 Jul 1996 4820-99-785-3883
4RNCC: 5 | RNVC: 9 | DAC: 4736MT/4RNCC: 5 | RNVC: 9 | DAC: 4 27 Aug 1992 4820-99-384-7235 Valve Disk 480
8197 Safety Relief Valve 2B/2BE162/CRNCC: 5 | RNVC: 1 | DAC: 4 27 Jan 1994 4820-99-661-1926 Valve Disk 480

Information is available for this item - Upgrade for $1 a day Upgrade your Account Upgrade 5975-00-480
United States (US) 4. 5975-00-480-0113 Marketplace Restrictions Approved Sources Datasheet Management
AN781-1 CABLE NIPPLE,ELECTRICAL 17 EA NS Request Quotation Updated Every Day 5975-00-480-0113 RQST NE

HMMWV TM-9-2320-280-34 Direct Support and General Support Maintenance Manual - M998, M998A1, M1025, M1025A1, M1025A2, M0126, M1026A1 and other models. Page 192 of 1258.

5330-00-798-5556 5330007985556 007985556 is a circular shaped item designed to be installed in a specially prepared groove or counterbore to provide a low pressure seal. it may be supplied in various cross-sectional shapes and is cut through at one point to allow for installation and fitting. excludes items whose primary function is to provide sealing, wiping, or wearing surface capabilities for piston configurations. see also ring, piston and ring, wiper.

5365-01-607-9150 5365016079150 016079150 is a thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole and having a solid rectangular cross-section use disk, solid, plain. items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. for items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. when thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. see also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.