4810-00-630-0025

5310-01-186-7784 5310011867784 011867784 is a washer which is usually round with a centrally located hole. its edges and two bearing surfaces are so designed that applied pressure brings into play the spring tension and/or frictional locking principle which materially resists any tendency toward turning. it may be made of one or two pieces

4810-01-167-8432 4810011678432 011678432 is an item usually metallic, threaded or unthreaded, used for securing to or positioning into a mating part. it is designed to be used in a globe, relief, regulator valve and the like as a means of controlling the flow of liquids or gases in a given system. one end may have an integral disk or be designed to accommodate a metallic or nonmetallic disk. the other end is designed for a handwheel, lever, spring, diaphragm and the like for nonpowered operation or to accommodate a gear, solenoid, air motor and the like for powered operation. the handwheel and/or disk may be furnished with the item. excludes stem, faucet; and stem, needle valve.

5310-01-186-7783 5310011867783 011867783 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

5310-01-186-7785 5310011867785 011867785 is a washer which is usually round with a centrally located hole. its edges and two bearing surfaces are so designed that applied pressure brings into play the spring tension and/or frictional locking principle which materially resists any tendency toward turning. it may be made of one or two pieces

5310-01-167-8409 5310011678409 011678409 is a nut having a flat bearing surface and 6 flat sides with slots in its upper portion. it is designed to provide positive locking when used with a solid or split (cotter) pin. excludes nut (1), plain, castellated, hexagon.