3110-15-155-6531

6145-99-767-2216 6145997672216 997672216 is two or more individually insulated conductors (solid or stranded) contained in a common covering, or two or more individually insulated conductors twisted or molded together without a common covering, and specifically designed for use in telephone lines or circuits. when there are over four conductors contained in a common covering, the majority of these conductors must be arranged in pairs, quads, or combinations thereof. refers to bulk quantities only; for items of definite length with processed ends or terminated in fittings, see cable assembly, telephone. excludes items having tinsel conductors, items having shields which cover less than the total number of conductors, or items rated for radio frequency characteristics.

4820-14-402-4843 4820144024843 144024843 is a valve with one inlet and one outlet connection that provides unobstructed fluid flow. the flow is controlled by the action of a stem which lifts disk perpendicularly off center axis of its seat. the stem is at angle of less than 90 degrees (1.5708 radians) to parallel inlet and outlet flow. it may utilize a diaphragm as packing. excludes valve, stop-check.

5306-14-542-6015 5306145426015 145426015 is an externally threaded fastener whose unthreaded portion is of a specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001) of an inch (0.025 mm) or less of a specific diameter for items one inch (25 mm) or less in diameter. items over one inch (25 mm) in diameter shall have a tolerance of fifteen ten-thousandths (0.0015) of an inch (0.038 mm) or less. the nominal major diameter of the threads shall be at least one thousandth (0.001) of an inch (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. the head is not designed to be held or driven with an inserted driver, nor is it designed for rotation by the thumb and fingers. a locking feature may be incorporated in the design of the head or threads. for items having close tolerance, and fabricated from material having 160,000 pounds per square inch (1100 megapascals) minimum tensile strength, see bolt, shear. for items fabricated from material having less than 160,000 pounds per square inch (1100 megapascals) minimum tensile strength and not having a close tolerance, see bolt, machine.

4320-14-297-9662 4320142979662 142979662 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

5995-99-147-8629 5995991478629 991478629 is a definite continuous length of cable, special purpose, electrical with branches (forks), and having one or more ends processed and/or terminated in fittings to provide for connection to other items. excludes lead, test. see also wiring harness.