3040-00-485-1141
Shouldered Shaft
3040004851141 004851141 177470
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT. View more Shouldered Shaft
November 2023
4
Marketplace 3040-00-485-1141
Request a Quotation from participating marketplace vendors
Related Documents 3040-00-485-1141 5+ Documents (More...)
for $1 a day Upgrade your Account Upgrade 6615-00-932-4312Sleeve Assembly6615009324312 009324312 177470
to enable JavaScript in your web browser . 3040-00-485-1141Shouldered Shaft3040004851141 004851141 177470
Shouldered Shaft 3040004851141 004851141 to enable JavaScript in your web browser . 3040-00-485
-1141Shouldered Shaft3040004851141 004851141 177470 enable JavaScript in your web browser . 4710-14-295
Restrictions 3040-00-485-1141
3040-00-485-1141 is a Shouldered Shaft This item is considered a low risk when released from the control of the Department of Defense. The item may still be subject to the requirements of the Export Administration Regulations (EAR) and the Code of Federal Regulations (CFR). This item is not suspected to be hazardous. The precious metals content of this item is unknown.
Approved Sources 3040-00-485-1141
- Part Number
- Manufacturer
- Status
- 177470
- Manufacturer
- 71791 - Curtiss-Wright Controls, Inc. (Active)
- Primary Buy
- Primary Buy