3040-00-046-2255

Documents 6920-00-775-0363 2+ Documents ( More... ) https//www.nsnlookup.com /fsg-30/fsc-3040/us 3040-00-046-2255
Shouldered Shaft 3040000462255 000462255 electrical-electronic component. https//www.nsnlookup.com

5330-00-238-7842 5330002387842 002387842 SEAL

5905-14-238-7842 5905142387842 142387842 is a resistor in which a sliding or rolling contact moves over an exposed area of the resistive element to change the ohmic value of the output. the functional tolerance (linearity), if given, of the output is greater than plus of minus 1 percent on linear outputs. specified outputs such as sine, cosine, tangent, etc., shall be considered to be precision. for items having manually positioned taps designed to be set and fixed prior to use, see resistor, adjustable. for items with step by step variation, see rheostat and resistor, step by step. for tandem-mounted items designed to function together as an attenuator (and rated accordingly), see attenuator, variable. excludes resistor (1), variable, nonwire wound, nonprecision; resistor (1), variable, nonwire wound, precision; and resistor (1), variable, wire wound, precision.

6150-01-238-7842 6150012387842 012387842 CABLE ASSEMBLY,SPECIAL PURPOSE,E

2530-12-122-3341 2530121223341 121223341 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.