3040-14-381-1815

3655-99-502-2533 3655995022533 995022533 CARTRIDGE KIT,WATER DEMINERALIZER

5935-00-502-2533 5935005022533 005022533 is an electrical fitting with electrical contacts constructed to be affixed to the end of a cable, conduit, coaxial line, cord, wire (includes printed/etched), printed wiring board, or the like for convenience in joining with another electrical connector(s) or printed wiring board. it is designed to be mounted on a bulkhead, chassis, panel, wall, printed wiring board, or the like. excludes lampholder; jack, telephone; jack, tip; insert electrical connector; insert module, electrical connector; connector body (as modified) and socket, plug-in electronic components. see also wiring harness (as modified) and cable assembly (as modified). for items with termination wires of more than four inches in length, see lead assembly, electrical. for items without inserts, see shell, electrical connector.

5330-14-411-4194 5330144114194 144114194 is an item fabricated from nonmetallic special shaped section. it may be (1) formed to a specific shape with or without joints, (2) a single piece whose ends have been secured together to form a specific shape, or (3) a straight item fabricated to a specific length for a specific application with end cuts or joints. items, except for molded corners, slot(s), press fit buttons, and the like must be of one continuous cross section. it is specifically designed for use in applications where there is no relative motion between joined parts. excludes bushing, nonmetallic; packing, performed; pad, cushioning;and seal, plain. for straight items with square end cuts and without mounting hole(s), slot(s), or press fit buttons, see nonmetallic special shaped section.

3040-01-411-4194 3040014114194 014114194 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

1220-37-502-2533 1220375022533 375022533 is a device designed in the form of a slide rule, having one or more scales of varying ranges, on either surface, and a plastic cursor with a matte to receive pencil markings of range correction. it is used with various types of ground and sky-sweeper weapons to determine quadrant elevation, angle of sight, or drift, and to calculate the trajectory of a projectile in relation to a target. it may contain scales for yards to meters conversion and gage points which are used in conjunction with the cursor and range scale to convert data given in meters to yards. scales may be in mils for determining high angle fire, time of flight, deflection shift, and the like.