3020-14-512-0606

Documents 5340-23-113-3813 5+ Documents ( More... ) https//www.nsnlookup.com /fsg-30/fsc-3020/fr 3020-14-512-0606
Groove Pulley 3020145120606 145120606,0053670 3020-14-512-0606 3020145120606 145120606 is a pulley

5331-16-005-3670 O-Ring 144,5,X3/1011-087RNCC: https//www.nsnlookup.com /fsg-30/fsc-3020/fr 3020-14-512-0606
Groove Pulley 3020145120606 145120606,0053670 resistor. excludes suppressor, ignition interference

5120-15-005-3670 5120150053670 150053670 WRENCH MONKEY

5905-01-005-3670 5905010053670 010053670 is a resistor whose ohmic value cannot be adjusted or varied. the resistance element consists of high resistance wire (or ribbon) either wound on an insulated form or constructed so as to be self supporting. opposition to the flow of current is an inherent property of the resistance wire and is manifest by the heat dissipation in the resistor. excludes suppressor, ignition interference.

5365-20-005-3670 5365200053670 200053670 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.