3010-14-349-0526

DAC: 2 1 Jan 1970 5330-14-272-4329 Metal Seal Ring 48100RNCC: 3 | RNVC: 2 | DAC: 2 1 Jan 1971 3010-14-349-0526

3040-01-209-2893 3040012092893 012092893 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.

3120-00-515-1502 3120005151502 005151502 is a tubular shaped item with or without flange(s) designed to reduce friction and carry a kinetic load on the surface(s) parallel to the axis of the bore. it must have a visible or detectable means of lubrication or be self-lubricated. the over all length must exceed 25 percent of the outside diameter or the shortest distance between peripheral flats of the body, except for straight tubular (without flange or shoulder) items having a bearing surface(s) parallel to the axis of the bore only. includes items which are divided into two or more segments which include 180 degrees (3.141 radians) or less of the bearing periphery. see also bushing, sleeve; spacer, sleeve; and washer (as modified). excludes pin, hollow.

3120-01-375-0300 3120013750300 013750300 is a tubular shaped unthreaded item with or without a flange at one end designed to be inserted into a hole to reduce the inside diameter of the hole and to protect the surrounding body structure from damage resulting from stress, strain, and/or vibration. the overall length must exceed 25 percent of the outside diameter or the shortest distance between peripheral flats of the body. includes items which are divided into two or more segments which includes 180 degrees (3.141 radians) or less of the bearing periphery. for items made of rubber, see bushing, nonmetallic. see also bearing, sleeve; bushing, tapered; spacer, sleeve; insulator, bushing; and bushing, electrical conductor. excludes bushing, drill, jig.

6520-14-387-1616 6520143871616 143871616 is a case which is specifically designed to accommodate dental instruments in all available sizes. it permits autoclaving of the instruments used in endodontic procedures and maintaining them under aseptic conditions for reasonable periods of time.