2915-15-109-8683

2915-33-156-2753 2915331562753 331562753 is an item that provides an automatic proportioning of fuel distribution to the engine fuel manifolds, under pressure, to achieve better fuel atomization at the fuel nozzles over a wide range of fuel flows. it must also provide a means of shutting off fuel supply to the engine and draining the fuel manifold after engine shutdown. it must be spring loaded and is either pressure balanced or linkage operated.

14-528-1917 Fuel Pressurizing And Drain Valve L94B31-202RNCC: 3 | RNVC: 2 | DAC: 1 9 Jan 2002 2915-15-109-8683

5330-01-481-0522 5330014810522 014810522 is a pliable rubber, felt, leather, or composition ring-shaped element, split or solid; with or without spring or spreader, having a metal shell on all or a portion of at least two of the outer surfaces. it may be designed to be either bolt mounted or pressmounted between fixed and moveable parts to form a tight and effective seal by the pressure of the spring or spreader or the resiliency inherent in the element material. excludes packing with retainer.

5365-14-481-0522 5365144810522 144810522 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.

5945-00-481-0522 5945004810522 004810522 RELAY-CAGING F-1 AN