2805-00-350-0455

5310-14-469-1013 5310144691013 144691013 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

6105-14-378-0217 6105143780217 143780217 is a motor which is designed for operation from either a single phase alternating current or direct current source.

1730-00-788-0171 1730007880171 007880171 SLING,AIRCRAFT MAINTENANCE

5310-01-670-0236 5310016700236 016700236 is an item of various shapes and sizes, having two flat bearing surfaces which may or may not be parallel. it is used in the manufacture of a washer by drilling or punching a hole in the center. excludes disk (as modified).

1560-01-626-9850 1560016269850 016269850 is a preformed metallic or nonmetallic sheet of various shapes and contours which is used as a segment of the covering of an airframe. it may be predrilled to facilitate mounting. excludes cloth, airplane