2590-12-387-9037

6625-00-150-5214 6625001505214 001505214 TEST SET SUBASSEMBLY,ELECTRICAL AND ELECTRONIC TEST EQUIPMENT

1560-01-150-5214 1560011505214 011505214 is a preformed metallic or nonmetallic sheet of various shapes and contours which is used as a segment of the covering of an airframe. it may be predrilled to facilitate mounting. excludes cloth, airplane

3040-15-150-5214 3040151505214 151505214 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.

5340-25-150-5214 5340251505214 251505214 is a bracket of various shapes (other than angle), designed to be attached to a supporting surface for the specific purpose of positioning, aligning and/or supporting another item. excludes brace (as modified); bracket, angle; and bracket, double angle. see also bracket (1), electrical connector; bracket, fire extinguisher; bracket, solenoid; bracket, track, sliding door; and retainer (as modified).

5315-12-150-5214 5315121505214 121505214 is a metallic item, usually square or rectangular in cross section, usually longer in relation to its width and thickness, with or without a head, usually designed to fit into the pre-cut slots of two adjacent cylindrically shaped members, to prevent relative rotational movement between the two. it may have mounting holes or slots.