2540-14-234-8063

RNVC: 9 | DAC: 6 1 Jan 1967 5330-14-291-3418 Gasket 178883RNCC: 5 | RNVC: 9 | DAC: 5 1 Jan 1972 2540-14-234-8063

5310-34-030-8089 5310340308089 340308089 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

2520-99-793-1935 2520997931935 997931935 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.

7690-99-259-6092 7690992596092 992596092 is a flexible item designed to be affixed to an object by adhesion or sewing to indicate contents, destination, or other similar identification. it may be blank with a surface designed for marking, preprinted, or have data woven into it. may be in roll form if perforations or markings are provided for detaching items of a specific length, or if separate labels are affixed to a continuous roll of backing material. excludes marker, identification; plate, identification; tape identification; and tape, pressure sensitive adhesive.