2540-12-134-1945

5865-01-309-5081 5865013095081 013095081 is a single component specifically designed to produce radio frequency signals to deprive the enemy of his electronic equipment through position fixing, signal identification, deception, and jamming with resultant tactical advantage to our own operating forces.

2920-12-142-1402 2920121421402 121421402 is a regulator designed to automatically maintain the current and/or voltage output of an engine generator within specified limits, regardless of variation of load or input voltages. may include cutout relay. does not include items in which regulation is accomplished by transformer action. see also regulator, current and regulator, voltage.

5905-99-142-1402 5905991421402 991421402 is a resistor whose ohmic value cannot be adjusted or varied. the resistance element consists of either a thin layer of conductive material, containing either binders or insulating materials, deposited on an insulated form; or an alloy of metal and ceramic materials, usually fused to an insulated form. opposition to the flow of current is an inherent property of the materials used and is manifest by the heat dissipation in the resistor. see also attenuator, fixed and resistor, fixed, composition. excludes carbon composition type resistors.

6685-15-142-1402 6685151421402 151421402 MANOMETRO

5365-01-142-1402 5365011421402 011421402 is a thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole and having a solid rectangular cross-section use disk, solid, plain. items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. for items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. when thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. see also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.