2530-16-003-3352

0802 Rubber Special Shaped Section Seal 443 9 3420 159 0RNCC: 3 | RNVC: 2 | DAC: B 29 Aug 2001 2530-16-003-3352

how to enable JavaScript in your web browser . 5310-16-001-0296Flat Washer5310160010296 160010296 402-1042.47

DAC: 2 25 Apr 1991 2530-66-154-9173 Thrust Pad 15014131RNCC: 3 | RNVC: 2 | DAC: E 5 Oct 2006 2530-16-003-3352

5310-16-002-0079 5310160020079 160020079 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

5977-16-006-5679 5977160065679 160065679 is an item specifically designed to be used in the transfer of electrical energy to or from another conducting surface. either the brush or the surface is continually moving during the transfer of energy. the brush is usually composed in part of some form of the element carbon. includes: (1) a single brush either with or without an attached shunt (flexible wire lead) and/or a helical or flat type pressure spring; (2) a split brush composed of two or more pieces (wafers), which are used in place of one brush usually connected together by individual shunts to a common terminal; (3) paired brushes composed of two identical or non-identical brushes connected together by a common shunt either with or without pressure springs or connected by individual shunts to a common terminal, or with pressure springs and connected to a common bar, bracket or the like either with or without individual shunts; (4) multiple brushes composed of more than two identical or non-identical brushes without pressure springs connected by individual shunts to a common terminal, or with pressure springs and connected to a common bar, bracket or the like by individual shunts. does not include moving contacts which make and slide past stationary contacts, but are stationary while the circuit is conducting, such as the sliding contacts on a rheostat or the stationary contact on a synchro. excludes: contact, electrical; and contact assembly, electrical.