2520-00-007-4697

https//www.nsnlookup.com /nato/nato-stock-numbers/inc Vehicular Propeller Shaft (INC 52086) 1967 2520-00-007-4697

Documents 2520-00-021-2378 3+ Documents ( More... ) https//www.nsnlookup.com /fsg-25/fsc-2520/us 2520-00-007-4697
Vehicular Propeller Shaft 2520000074697 https//www.nsnlookup.com /nato/nato-stock-numbers/inc Vehicular

4820-15-192-3194 4820151923194 151923194 is a multi-ported, nonlubricated valve designed to provide straight through flow or ability to direct a number of flows or pressure through a single valve. the flow is controlled by the rotation of a ported ball within a suitable ported seat(s). the ball is usually engaged by a stem. it is normally operated in an open or closed position. excludes valve, check.

5962-01-192-3194 5962011923194 011923194 is a microcircuit specifically designed to generate, modify, or process electrical signals which operate with two distinct or binary states. these states are commonly referred to as on and off, true and false, high and low, or "1" and "0".

5365-12-300-1053 5365123001053 123001053 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.