2510-25-152-4941

6145-25-151-6236 Electrical Special Purpose Cable 1023282RNCC: 3 | RNVC: 2 | DAC: 9 20 Aug 2004 2510-25-152-4941

5310-33-102-0304 5310331020304 331020304 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

4130-15-102-0304 4130151020304 151020304 CILINDRO COMPRESSOR

5331-99-102-0304 5331991020304 991020304 is a nonmetallic circular item with an aperature, having a solid round cross-section. they are used primarily for sealing. for items with other than round cross section, see packing,preformed. for noncircular items with a round cross-section, see seal,nonmetallic round section and rubber,round section.

5306-01-102-0304 5306011020304 011020304 is an externally threaded fastener whose unthreaded portion is of a specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001) of an inch (0.025 mm) or less of a specific diameter for items one inch (25 mm) or less in diameter. items over one inch (25 mm) in diameter shall have a tolerance of fifteen ten-thousandths (0.0015) of an inch (0.038 mm) or less. the nominal major diameter of the threads shall be at least one thousandth (0.001) of an inch (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. the head is not designed to be held or driven with an inserted driver, nor is it designed for rotation by the thumb and fingers. a locking feature may be incorporated in the design of the head or threads. for items having close tolerance, and fabricated from material having 160,000 pounds per square inch (1100 megapascals) minimum tensile strength, see bolt, shear. for items fabricated from material having less than 160,000 pounds per square inch (1100 megapascals) minimum tensile strength and not having a close tolerance, see bolt, machine.