2510-14-409-9493

2840-20-002-4619 2840200024619 200024619 is a support designed for a seal used in an aircraft gas turbine engine.

enable JavaScript in your web browser . 1680-14-472-8833Deflecteur1680144728833 144728833 332A58-1814-21
Netherlands (ZN) Greece (ZU) Approved Sources 1680-14-472-8833 Part NumberManufacturerStatus332A58-1814-21

21-865-2630 218660755 3401 866-0680 6810-21-864-0914 6810-21-868-2980 6810-21-862-8330 6810-21-866-1814 21
218628330 2847 866-0755 6810-21-866-0680 6810-21-864-0914 6810-21-868-2980 6810-21-862-8330 6810-21-866-1814 21

5340-14-388-1814 5340143881814 143881814 is an item specifically designed to fit over the opening(s) of various items to provide mechanical protection and/or to prevent the entrance of foreign matter during painting, shipping, storage, or the like. it is not designed to retain fluids under pressure during equipment operation. excludes cover, electrical connector; hood, sealing, bottle; and stopper, bottle. for items designed to fit into or over the opening(s) of various items, see cap-plug, protective, dust and moisture seal.

5310-12-149-7611 5310121497611 121497611 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.