1355-01-180-4685

www.nsnlookup.com /fsg-13/fsc-1355 Torpedos and Components, Inert from United States (US) 1900 1355-01-180-4685

Jan 1900 1355-01-210-5681 1 Jan 1900 1355-01-190-8739 1 Jan 1900 1355-01-181-7714 1 Jan 1900 1355-01-180-4685

3040-99-554-8843 3040995548843 995548843 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

5340-14-554-8843 5340145548843 145548843 is a clamp designed to surround other item(s) such as cable(s), conduit(s), pipe(s), hose(s), or tube(s), and to fasten together or to another object or structure. includes straight flexible items. for items specifically designed to clamp a hose to a connection to prevent leakage, see clamp, hose. see also hanger, pipe and clip, spring tension. for retaining straps with a bridge, see strap, retaining. excludes clamp, electrical; band, retaining; clamp (1), c; bracket pipe.

5310-01-554-8843 5310015548843 015548843 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.