1350-01-024-7262

Documents 6645-15-126-6446 5+ Documents ( More... ) https//www.nsnlookup.com /fsg-13/fsc-1350/us 1350-01-024-7262
Underwater Acoustic Transmitter 010247262 valve, graphite impregnated and lubricated items. https

3040-12-337-0453 3040123370453 123370453 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

3040-12-337-0454 3040123370454 123370454 is a gearshaft with one or more complements of helical gear teeth and one or more complements of spur gear teeth.

5310-21-842-7378 5310218427378 218427378 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

3040-12-337-0455 3040123370455 123370455 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.