1015-99-449-8475

Here are instructions how to enable JavaScript in your web browser . 1015-99-449-84751015994498475 994498475
United Kingdom (UK) 4. 1015-99-449-8475 Marketplace Restrictions Approved Sources Datasheet Management
Request a Quotation from participating marketplace vendors Request Restrictions 1015-99-449-8475 DEMIL

your web browser . 1015-21-330-8486Pipe1015213308486 213308486 NOD3197-75 NOD3197-14S1 180590 1015-99-449-8475
Documents 1015-21-330-8486 5+ Documents ( More... ) https//www.nsnlookup.com /fsg-10/fsc-1015/uk 1015-99-449-8475
1015994498475 994498475 United Kingdom (UK) 4. 1015-99-449-8475 Marketplace Restrictions Approved

5940-00-138-8837 5940001388837 001388837 is an item consisting of insulating material, which is specifically designed to have fastened thereon, or on which are fastened terminal(s), such as screws, solder lugs, solder studs, solderless connectors, clips, and the like. it is usually used for junctions or terminations of wire or cable assemblies. it does not include items as defined above with parts, such as resistors and capacitors mounted thereon. do not use if a more specific name exists, such as fuseholder; holder, resistor; fanning strip; contact assembly, electrical; jack assembly, tip; chamber, cable terminal; panel (2) (as modified); connector (as modified). excludes terminal, stud; terminal, feedthru, insulated; post, binding, electrical; and chassis, electrical-electronic equipment. for items having printed electrical conductor paths, see printed wiring board.

5365-99-606-5208 5365996065208 996065208 is a flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole having a solid rectangular cross-section use disk, solid, plain. for round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see spacer, sleeve. the thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. for items with a thickness less than those indicated above, see shim. for items with one hole centrally located conforming to the above dimensional criteria use washer, flat or spacer, ring as applicable. when thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. excludes gasket&#59; insulator (as modified) and mounting pad, electrical-electronic component.

ca 1015-21-330-8486 Pipe 1015213308486 213308486,NOD3197-75 HMIC : | PMIC : | EDC: | ADPEC : 1015-99-449-8475