1005-12-350-5890

8538 https//www.nsnlookup.com /fsg-10/fsc-1005 Guns, through 30mm from Germany (DE) 16 May 1978 1005-12-350-5890

14 Nov 2008 1005-12-173-8293 Abz Anschlagstueck 202403RNCC: 3 | RNVC: 9 | DAC: 3 16 May 1978 1005-12-350-5890

5330-99-544-2682 5330995442682 995442682 is a deformable material which prevents the passage of matter through the joint formed when two faces are joined. it may be metallic or nonmetallic, lubricated or impregnated, solid or hollow cross section. it may be made to any predetermined dimension and shape. excludes flat disks, items made of felt material and items having joints. for round metal and plastic items with an aperture and a solid rectangular cross section, see washer, flat; shim; bearing, washer, thrust; and spacer ring. excludes disk, valve; seal, nonmetallic angle; seal, nonmetallic channel; seal, nonmetallic special shaped section; shielding gasket, electronic; and ring, sealing jar.

5310-14-265-2336 5310142652336 142652336 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

3040-99-016-0747 3040990160747 990160747 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.