1005-12-318-8048

3010-12-317-4110 3010123174110 123174110 HEBEL, AUSRUECK-, R

3040-12-319-3947 3040123193947 123193947 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

3020-12-319-3526 3020123193526 123193526 is a cylindrical item having a full 360 degree (6.282 radians) complement of teeth on two or more surfaces. it may be a one-piece casting or composed of two or more separate items firmly held together by welding, rivets, pins, or the like, to form a single unit. it is designed to mount on a shaft. for items consisting of a shaft with an integral complement(s) or gear teeth, see gearshaft (as modified). excludes gear subassembly, speed decreaser.

3110-12-319-0316 3110123190316 123190316 is a comparatively flat rigid item, with or without a centrally located aperture, designed to hold an annular bearing or a sleeve bearing in a fitted inclosure. it must have drilled and/or tapped holes for mounting purposes. excludes end bell, electrical rotating equipment.

3040-12-319-3946 3040123193946 123193946 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.