TM-9-2350-273-BD M60 M48 Battle Damage Assessment and Repair Download
Page 212 of 288
NOTE c D E F G H I J K L TM 9-2350-273-BD COMMUNICATIONS SYSTEM BUT if the CALL light does not come on, the switch is in NORMAL. Organizational or higher maintenance should then: Remove R/T from mount, turn R/T upside down. Remove bottom cover from R/T. Loosen assembly A4000 captive screws. Raise assembly A4000 and lock brace. Turn X-MODE-NORMAL switch to X-MODE. Be sure leaf springs are equally curved. Lower assembly A4000 and tighten captive screws. Be sure assembly hinge pin is pushed all the way in. Replace bottom cover of R/T. Replace R/T on to mount. If the AUX receiver is to be used in the X-MODE communications hookup it must be opened up and its switch set to X-MODE. . . The AUX receiver switch must be placed in NORMAL after you are through with the X-MODE hook-up. #10 - Loss of automatic channel selection if RT-246 is being used. 11-57