TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 88 of 772
TM 9-2350-260-20-1-2 TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 4) NOTE It may be necessary to turn universal joint to gain access to screw (L). 8. Using 3/4 inch socket, remove three screws (L) and lockwashers (M) from bracket (C). Throw lockwashers away. 9. Remove bracket (C) from transmission. 10. Using hammer, remove spacer (N) from bracket (C). CLEANING AND INSPECTION: 1. Inspect bushing, mounts, and roller for damages. If any parts are nicked, burred, or out- of-round, replace damaged part. 2. Clean all parts with dry cleaning solvent (Item 54, Appendix D) and wipe dry with rags (Item 65, Appendix D). INSTALLATION: 1. Position bracket (A) in vise and, using resilient mount mechanical puller (Item 34, Chapter 3, Section I), install two mounts (B) into bracket (A). 2. Using 3-1/8 inch socket and T-slide wrench, install bushing (C) into bracket (A). Go on to Sheet 4 TA147465 6-11