TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 767 of 772
TM 9-2350-260-20-1-2 FAN DRIVE OIL SEAL REPLACEMENT (Sheet 4 of 5) 3. Using hammer and brass drift, drive new seal (A) into housing (B), seating seal. Remove excess sealing compound. 4. Position assembled oil seal housing (B) on fan drive housing (C). Be sure puller holes in housing (B) aline with indents in fan housing (C). 5. Install and hand tighten six bolts and washers (D) finger tight. 6. Using torque wrench, tighten bolts (D) to 150-175 lb-in (17-20 N•m). Go on to Sheet 5 TA146911 9-65