Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 76 of 772

TM 9-2350-260-20-1-2 2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 15 of 16) WARNING Fuel is delivered under high pressure from fuel pump to injector nozzles. Injury to personnel could result if contacted by spray from loose or defective fuel line. CAUTION DO NOT run engine for more than 10 minutes and do not exceed 700-750 rpm. WARNING Take all necessary safety precautions to eliminate possible injury to personnel or damage to equipment. Stand clear of both transmission output flanges whenever the engine is running. Hearing protection is required. 8. Start engine and run engine at idle speed (700-750 rpm) (TM 9-2350-260-10). 9. Wearing goggles, check for leakage at all fuel line connections. 10. If leak is observed, shut down engine (TM 9-2350-260-10) and tighten or replace bad fuel line or fittings. 11. When no leaks are observed, shut down engine (TM 9-2350-260-10). 12. Using 1-1/4 inch socket remove cooling fan nut. 13. Remove spacers from fan drive shafts. 14. Install cooling fans (page 9-49). 15. Install left bank engine access covers 2A engine (page 6-86) or 2D engine (page 6-91). 16. Install right bank engine access covers 2A engine (page 6-78 or 2D engine (page 6-82). 17. Install engine shroud (page 9-3). Go on to Sheet 16 TA147966 5-66