Sign up to sell your inventory with NSN Lookup

TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download

Page 752 of 772

TM 9-2350-260-20-1-2 ENGINE COOLING FAN REPLACEMENT (Sheet 4 of 4) 4. Install assembled fan and hub on shaft (E). 5. Using 1-1/4 inch socket, install washer and hex nut (F). Using torque wrench, tighten nut from 45- 55 lb-ft (61-75 N•m). 6. Using feeler gage, check clearance between fan (H) and housing (J). If clearance is less than 0.62 inch all around, go to page 9-58, step 17, for adjustment procedures. 7. Using 1-1/4 inch socket and torque wrench, turn nut (F) clockwise and check that clutch releases (fan turns) between 20-25 ft-lb (27-34 N•m). If clutch does not release between 20-25 lb-ft (27-34 N•m), notify support maintenance. 8. Using slip joint pliers, install new cotter pin (G). 9. Position fan cover (K) over fans. 10. Using 9/16 inch socket, install four screws and new lockwashers (L). 11. Install top deck (page 16-22). End of Task TA146896 9-50