TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 751 of 772
TM 9-2350-260-20-1-2 ENGINE COOLING FAN REPLACEMENT (Sheet 3 of 4) 6. Using slip joint pliers, remove 16 cotter pins (G) and throw away. 7. Using 1/2 inch socket and wrench, remove 16 nuts, bolts, and washes (H) holding fan (J) to hub K). 8. Place block of wood on hub (K). Using hammer, strike block wood until hub (K) is separated from fan (J). 9. Inspect hub (K) for damages. Replace hub if damaged. INSTALLATION: 1. Position hub (A) on fan (B), machined surface up (marked TOP). 2. Using 1/2 inch socket and open end wrench, install 16 bolts, nuts, and washers (C). Using torque wrench, torque nut to 1-20 lb-ft (227 N•m). 3. Using slip joint pliers, install 16 new cotter pins (D). Go on to Sheet 4 TA146895 9-49