TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 742 of 772
TM 9-2350-260-20-1-2 TRANSMISSION SHROUDS REPLACEMENT (Sheet 2 of 8) Right Intermediate Shroud Replacement REMOVAL: NOTE When removing the right intermediate shroud on a 2A engine, remove engine wiring harness according to page 10-338, steps 1 thru 7 and proceed to step 5 of this procedure. When removing the rigid intermediate shroud on a 2D engine, start with step 1 of this procedure. 1. Using spanner wrench, disconnect connector (A) from generator connector. 2. Remove grommet (B) from shroud (C) and cable assembly (D). 3. Inspect grommet (B) for defects. If defective, replace grommet. 4. Pull cable assembly (D) through shroud (C). Go on to Sheet 3 TA146886 9-40